INCH-POUND
MIL-DTL-15659J
15 December 2003
SUPERSEDING
MIL-T-15659H
1 October 1987
DETAIL SPECIFICATION
TERMINAL, LUG: SOLDER, COPPER AND PHOSPHOR BRONZE
Inactive for new design after 15 December 2003
This specification is approved for use by all departments and agencies of the Department
of Defense.
1. SCOPE
1.1 Scope. This specification covers copper and phosphor bronze or tin brass strip
solder electrical lug terminals.
1.2 Classification. Lug terminals will be of the following classes as specified (see 6.2):
Class 1 - Stamped copper sheet
Class 2 - Punched copper tubing
Class 3 - Stamped phosphor bronze or tin brass strip (locking type terminal)
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this specification
or recommended for additional information or as examples. While every effort has been made to
ensure the completeness of this list, document users are cautioned that they must meet all specified
requirements of the documents cited in sections 3 and 4 of this specification, whether or not they
are listed.
Comments, suggestions, or questions on this document should be addressed to Defense Supply
Center Richmond, ATTN: DSCR-VEB, 8000 Jefferson Davis Highway, Richmond, VA 23297-
5616 or e-mailed to STDZNMGT@dla.mil. Since contact information can change, you may
want to verify the currency of this e-mail address information using the ASSIST Online database
at www.dodsssp.daps.mil.
AMSC N/A
FSC 5940
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business