MS51535C
AWG
TABLE I. Dash numbers and dimensions.
1American Wire Gauge.
REQUIREMENTS:
1. Material: Electrolytic copper strip or sheet alloy C11000, temper 060 in accordance with ASTM B 152/B152M (DoD adopted).
2. Finish: Tinned; electrodeposited over entire surface in accordance with ASTM B 545 (DoD adopted). Minimum thickness 0.0005 inches all over.
N0TES:
1. Dimensions are in inches.
2. Unless otherwise specified, tolerance is ±0.015.
3. Remove all burrs.
4. Referenced documents of issue in effect on date of invitation for bids shall apply.
5. Dash number 6 shall conform to the optional configuration shown in figure 1.
6. In the event of a conflict between the text of this document and the references cited herein, the text of this document shall take precedence.
7. The part or identifying number (PIN) consists of the letters MS, the specification sheet number, and a dash number taken from table I.
MS 51535 - 3
Dash number
Specification sheet number
MS prefix
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business